Description
The ultimate in cyanoacrylate fuming!
This chamber features 4.0 cu. ft. (.11 cu. meters) of volume for processing a large number of items at once. Two heating elements, operating independently or simultaneously, allow for safe cyanoacrylate fuming with a surface temperature of approximately 230OF (110OC).
Closely monitor latent print development through the clear, polycarbonate front door panel. By utilizing the built-in control print hanger, the guesswork is taken out of fuming time! NOTE: Overdeveloped prints lose detail, hindering enhancement techniques ”it’s always better to underdevelop.
One of the most outstanding features are the two inlet ports ”use the top port for fuming with the CYANOWANDâ„¢ (No. SCW101) and adding moisture as required with the No. PUM100 Portable Humidifier; the lower port is designed for extracting fumes with the No. FR300 DeFumigatorâ„¢ after processing. NOTE: If your department processes a large number of latent prints with cyanoacrylate, use OMEGAPRINT â„¢ Fingerprint Developer (No. CNA103) and the Disposable Fuming Trays (No. CNA106).
In order to prevent the buildup of cyanoacrylate on the polycarbonate surfaces of your new fuming chamber, use the CNA110A CYANO-BLOCâ„¢ pre- and post-treatment pads before initial fuming.
*This chamber should not be used with Ninhydrin, Iodine fuming, DFO, Silver Nitrate or any solvent-based processing method.
FR200 CONTENTS:
1- FR200 Cyanoacrylate Fuming Chamber
1- CNA103 OMEGA-PRINTâ„¢ Fingerprint Developer, 16 oz. (454g)
1- CNA106 OMEGA-PRINTâ„¢ Disposable Fuming Trays, 25 ea.
1- CNA104 OMEGA-PRINTâ„¢ Dispersal Pads, 100 ea.
2- CNA20001 FINDERâ„¢ Cyanoacrylate Packets
1- CNA110A CYANO-BLOCâ„¢ pre- and post-treatment pads
1- FR201 Fuming Control Cards, pad of 50
1- FR1002 Fuming Platform, wire mesh
4- Evidence Support Rods
16- FR1006 Evidence Clips
